To make the handle, well, in conclusion, it’s gonna take about an hour to make the handle. The handle is deeply to adapt the groove which was led in the edge of the base. It is 1 round (on three sides) and has a hole of 7/8 in it. Since the edges of the hole must be round surplus I started with a piece mahogany tree which was 2 broad and 12 long. I had the diameter external with a square corner and marked the center of the handle. To drill the 7/8 initially hole. Then, by using one the 1/8 little of round over with a guide of bearing in thats of router gone up in a table of router, relieves the edges of the hole on the two sides.
On the table saw, crosscut the piece of wood with approximately 1. On the end with long grain of the square corner, to put a mark on the edge which corresponds to the center of the hole that you drilled inside the base. With a little in the drill to tighten and a barrier to strengthen the mean piece of wood, drill a hole deeply. To cut now the handle outside on the band saw. To remember only three corners to obtain round; the fourth corner with the hole in the place with long grain of the remainders. To sandpaper smooth and relieve the...
To view and download this full PLR article, you must be logged in. Registration is completely free. Once you create your account, you will be able to browse, search & downlod from our PLR articles database of over "1,57,897+" on 1,000's of niches and 200+ categories without paying a penny. Click here to signup...
