Fix the base in the turn with the stick to cross in octagon, stick it to the base by using a piece of finger. While this dries is a good time to manufacture a plate before special holding the base in the turn. The tail stock holds the end of the stick. My plate before made on order started by an aluminum 3 dish (6). I screwed a piece of 1 – the thick hard maple which had been cut the circle to 3 with him and to the bottom turned him with just more than 3 of diameter beside the 3 below metal plate and right on the other end. To drill one 3/16 hole in the center while the front plate is still assembled on the headstock. To cut a piece of 3/16 – the steel stem of diameter approximately to 1 .
Throw in the pressure and the file of drill or to rectify the end at a very pointed point while the stem turns. To stick this stem in the hole in the plate before so that only 1/8 to 5/32 of the point is proud surface. The metal plate I employed has two sets of holes of support. I was accustomed to the external holes to screw the dish with the face out of wooden. I drilled holes by the face out of wooden by the interior whole of holes of support. Then I ran 1 the screws...
To view and download this full PLR article, you must be logged in. Registration is completely free. Once you create your account, you will be able to browse, search & downlod from our PLR articles database of over "1,57,897+" on 1,000's of niches and 200+ categories without paying a penny. Click here to signup...
